TM 5-2410-240-23-2
0049
ENGINE CONTROL MODULE BRACKET INSTALLATION CONTINUED
00049
WARN I N G
Fuel is combustible and an irritant. Skin and eye protection is required. Ensure work area
is well ventilated.
Keep away from open flame and other ignition sources. Failure to follow this warning may
cause injury or death to personnel.
Do not bend high pressure fuel line to gain access for ECM mounting bracket installation.
The fuel system operates under extremely high pressure. Bending, loosening, or
retightening high pressure fuel lines renders them weaker and prone to failure. Replace
any high pressure fuel line that has been bent, loosened, and/or retightened. Failure to
follow this warning may result in serious injury or death to personnel.
4. Ensure ECM bracket (Figure 6, Item 1) is seated under fuel rail (Figure 6, Item 2) and tighten two bolts
(Figure 6, Item 4).
5. Install three bolts (Figure 6, Item 3) to fuel rail (Figure 6, Item 2).
Figure 6. Fuel Rail Bracket.
0049
END OF TASK
ENGINE CONTROL MODULE INSTALLATION
00049
N OT E
Install wires and pipes as noted during removal.
1. Connect wiring harness (Figure 7, Item 17) and install three new tiedown straps (Figure 7, Item 18) on ECM
(Figure 7, Item 10).
2. Install ECM (Figure 7, Item 10), four washers (Figure 7, Item 6), and bolts (Figure 7, Item 7) on machine.
3. Install three clamps (Figure 7, Item 14), nut (Figure 7, Item 13), and three new tiedown straps (Figure 7,
Item 15) on ECM wiring harness (Figure 7, Item 12).
4. Connect electrical connector (Figure 7, Item 16).
5. Connect two connectors (Figure 7, Item 9) on ECM (Figure 7, Item 10), and tighten two bolts (Figure 7, Item 8).
6. Install new tiedown strap (Figure 7, Item 11) on ECM harness (Figure 7, Item 12).
7. Position hose (Figure 7, Item 1), install clamp (Figure 7, Item 5), nut (Figure 7, Item 4), and bolt (Figure 7,
Item 2) on bracket (Figure 7, Item 3).