TM 5-2410-240-23-2
0072
PRIME PUMP LEVEL SENSOR INSTALLATION
00072
N OT E
Install wires and wiring harnesses as noted during removal.
1. Install liquid level sensor (Figure 3, Item 6), washer (Figure 3, Item 4), and bolt (Figure 3, Item 5) on machine.
2. Connect engine harness (Figure 3, Item 2) on liquid level sensor (Figure 3, Item 6), and install new tiedown
strap (Figure 3, Item 3) on (Figure 3, Item 2) engine harness.
3. Install new tiedown strap (Figure 3, Item 1) on bracket (Figure 3, Item 8).
4. Position harness (Figure 3, Item 7) on machine, and install three new tiedown straps (Figure 3, Items 9, 10, 11)
on harness (Figure 3, Item 7).
END OF TASK
PRIME PUMP LEVEL SENSOR PROBE INSTALLATION
00072
1. Install new O-ring (Figure 4, Item 2) on sensor (Figure 4, Item 3).
2. Install sensor (Figure 4, Item 3) on water separator (Figure 4, Item 1).
3. Close drain valve (Figure 4, Item 4) on separator (Figure 4, Item 1) and remove drain pan from under machine.
4. Connect wire (Figure 4, Item 5) on sensor (Figure 4, Item 3).
Figure 4. Prime Pump Level Sensor Probe.
0072