TM 5-2410-241-23-1
0032
BLADE LIFT CYLINDER CYCLE TEST
00032
1. Start machine and allow it to run for 15 minutes to reach normal operating temperature (TM 5-2410-241-10).
2. Ensure that blade is at rest flat on the ground (TM 5-2410-241-10).
3. Fully engage blade lift control to the FULL LIFT position (TM 5-2410-241-10). Blade should travel from
GROUND position to FULL LIFT position in 4.3 seconds or less.
4. Lower blade to the ground (TM 5-2410-241-10).
5. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
END OF TASK
BLADE TILT CYLINDER CYCLE TEST
00032
1. Start machine and allow it to run for 15 minutes to reach normal operating temperature (TM 5-2410-241-10).
2. Ensure that blade is at rest, flat on the ground (TM 5-2410-241-10).
3. Engage blade lift control to raise blade approximately 2 feet (0.6 m) off the ground (TM 5-2410-241-10).
4. Fully engage blade tilt control to move blade to FULL TILT RIGHT position (TM 5-2410-241-10).
5. Fully engage blade tilt control to the FULL TILT LEFT position (TM 5-2410-241-10). Blade should travel from
FULL TILT RIGHT position to FULL TILT LEFT position in 2.4 seconds or less.
6. Lower blade to the ground (TM 5-2410-241-10).
7. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
END OF TASK
RIPPER LIFT CYLINDER CYCLE TEST
00032
1. Remove three ripper shanks from machine (WP 0281).
2. Start machine and allow it to run for 15 minutes to reach normal operating temperature (TM 5-2410-241-10).
3. Ensure that ripper frame is at rest on the ground.
4. Set machine to HIGH IDLE (RABBIT MODE) on the throttle switch (TM 5-2410-241-10).
5. Fully engage ripper lift control to the FULL LIFT position (TM 5-2410-241-10). Ripper should travel from
GROUND position to FULL LIFT position in 2.8 seconds or less.
6. Set machine to LOW IDLE (TURTLE MODE) on the throttle switch (TM 5-2410-241-10).
7. Lower ripper to the ground (TM 5-2410-241-10).
8. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
END OF TASK
0032-16
