TM 5-2410-241-23-1
0032
BLADE LIFT CYLINDER DRIFT TEST
00032
1. Start machine and allow it to run for 15 minutes to reach normal operating temperature (TM 5-2410-241-10).
2. Ensure implement lockout switch is in UNLOCK position and blade is at rest, flat on the ground (TM 5-2410-
241-10).
3. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
4. Measure length of cylinder shaft (Figure 15, Item 1) and mark shaft at 1/2 the distance.
5. Start machine (TM 5-2410-241-10).
6. Raise blade to marked position (TM 5-2410-241-10).
7. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
8. Cylinder shaft (Figure 15, Item 1) should NOT DRIFT OVER 1.5 inches (38.1 mm) within 5 minutes. If cylinders
DRIFT OVER 1.5 inches (38.1 mm) within 5 minutes, replace blade lift cylinders (WP 0266).
9. Start machine (TM 5-2410-241-10).
10. Lower blade to the ground (TM 5-2410-241-10).
11. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
Figure 15. Blade Lift Cylinder Drift Test.
0032
END OF TASK
