TM 5-2410-241-23-2
0122
ADJUSTMENT
000122
N OT E
Tag and mark all electrical connections to aid installation.
Refer to Torque Limits (WP 0298).
1. Remove tiedown strap (Figure 4, Item 2) from connector (Figure 4, Item 1).
2. Disconnect connector (Figure 4, Item 3) from connector (Figure 4, Item 1).
3. Loosen nut (Figure 5, Item 2) and remove sensor (Figure 5, Item 1) from housing (Figure 5, Item 3).
4. Center gear tooth (Figure 5, Item 5) to align with sensor (Figure 5, Item 1).
5. Install sensor (Figure 5, Item 1) until sensor tip (Figure 5, Item 4) touches gear tooth (Figure 5, Item 5).
6. Set gap between sensor tip (Figure 5, Item 4) and gear tooth (Figure 5, Item 5) by turning sensor (Figure 5,
Item 1) 180 degrees counterclockwise.
7. Hold sensor (Figure 5, Item 1) and tighten jam nut (Figure 5, Item 2) to 18 lb-ft (25 Nm) on housing (Figure 5,
Item 3).
Figure 5. Sensor Adjustment.
0122