• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Table 1. Cab Troubleshooting Procedures - Continued.
Table 1. Cab Troubleshooting Procedures - Continued.

Field Maintenance Manual 1 D7R Dozer Type I With Winch and Type II With Ripper
Page Navigation
  726    727    728    729    730  731  732    733    734    735    736  
img
. . . . . . .
TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ROPS Mounted Forward
16. Using digital multimeter (WP
1. If continuity is found, proceed to
Facing Flood Lamp(s)
0296), test for continuity between
step 17.
Do Not Work - Continued
pin 3 on left rear flood lamp har-
2. If continuity is NOT found, replace
ness TK-C3 (WP 0018, Figure
left rear flood lamp harness (WP
103) and pin 1 on left rear flood
0154). Ensure all harness con-
lamp harness connector TK-C2
nectors are reconnected. Verify
(WP 0018, Figure 101).
correct operation of machine (TM
5-2410-241-10).
17. Using digital multimeter (WP
1.
If continuity is found, replace fuel
0296), test for continuity between
tank harness (WP 0170). Ensure
pin 4 on left rear flood lamp har-
all harness connectors are recon-
ness connector TK-C3 (WP 0018,
nected. Verify correct operation of
Figure 103) and pin 2 on left rear
machine (TM 5-2410-241-10).
flood lamp harness connector TK- 2.
If continuity is NOT found, replace
C2 (WP 0018, Figure 101).
left rear flood lamp harness (WP
0154). Ensure all harness con-
nectors are reconnected. Verify
correct operation of machine (TM
5-2410-241-10).
18. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
19. Disconnect right rear flood lamp
harness connector TJ-C2 (WP
0018, Figure 102) from right side
ROPS- mounted forward facing
flood lamp.
20. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-241-10).
21. Turn main light switch to Flood-
light position (TM 5-2410-241-10).
22. Using digital multimeter (WP
1. If 24 Volts is found, proceed to
0296), measure for voltage
step 23.
between pin 1 and 2 on right rear
2. If 24 Volts is NOT found. Proceed
flood lamp harness connector TJ-
to step 29.
C2 (WP 0018, Figure 102).
23. Turn main light switch to OFF
position (TM 5-2410-241-10).
24. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
25. Remove and disassemble right
ROPS-mounted forward facing
flood lamp (WP 0210).
0022-16


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved.