TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ROPS Mounted Forward
41. Using digital multimeter (WP
1. If 24 Volts is found, proceed to
Facing Flood Lamp(s)
0296), measure for voltage
step 42.
Do Not Work - Continued
between pin 1 and 2 on left rear
2. If 24 Volts is NOT found, proceed
flood lamp harness connector
to step 52.
TK-C2 (WP 0018, Figure 101).
42. Turn main light switch to OFF
position (TM 5-2410-241-10).
43. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
44. Remove and disassemble right
ROPS-mounted forward facing
flood lamp (WP 0210).
45. Inspect inside of right ROPS-
1. If corrosion or damage is found,
mounted forward facing flood
replace right ROPS-mounted for-
lamp for corrosion and damage.
ward facing flood lamp assembly
(WP 0252). Proceed to step 48.
2. If corrosion and damage is NOT
found, proceed to step 46.
46. Using digital multimeter
1.
If continuity is found, proceed to
(WP 0296), test for continuity
step 47.
between pin 1 and terminal 4 on
2.
If continuity is NOT found, replace
right ROPS -mounted forward fac-
right ROPS-mounted forward fac-
ing flood lamp (WP 0018, Figure
ing flood lamp assembly (WP
180).
0252). Proceed to step 48.
47. Using digital multimeter
1. If continuity is found, replace right
(WP 0296), test for continuity
ROPS-mounted forward facing
between pin 2 and terminal 3 on
flood lamp bulb (WP 0252).
right ROPS-mounted forward fac-
Proceed to step 48.
ing flood lamp (WP 0018, Figure
2. If continuity is NOT found, replace
180).
right ROPS-mounted forward fac-
ing flood lamp assembly (WP
0252). Proceed to step 48.
48. Remove and disassemble left
ROPS-mounted forward facing
flood lamp (WP 0252).
49. Inspect inside of left ROPS-
1. If corrosion or damage is found,
mounted forward facing flood
replace left ROPS-mounted for-
lamp for corrosion and damage.
ward facing flood lamp assembly
(WP 0252). Ensure all harness
connectors are reconnected. Ver-
ify correct operation of machine
(TM 5-2410-241-10).
2. If corrosion and damage is NOT
found, proceed to step 50.
0022-19