TM 5-2410-241-23-1
0033
IMPLEMENT PUMP DISCHARGE TESTS CONTINUED
High Pressure Cutoff Test
0033
36. Release parking brake (TM 5-2410-241-10).
37. Ensure lockout switch is in LOCK position (TM 5-2410-241-10).
38. Set machine to HIGH IDLE (RABBIT MODE) on the throttle switch (TM 5-2410-241-10).
39. Apply service brake (TM 5-2410-241-10).
WARN I N G
Ensure service brake is fully applied prior to position steering control handle in MID
STEER LEFT position. Failure to follow this warning may result in injury or death to
personnel.
40. Slowly apply steering control handle to MID STEER LEFT position (TM 5-2410-241-10).
41. Pressure gauge (Figure 7, Item 1) should read 5,485 to 5,685 psi (37,800 to 39,200 kPa). Record pressure
readings on gauge.
a. If pressure reading is NOT within specification, proceed to step 42.
b. If pressure reading is within specification, proceed to step 61.
42. Return steering control handle to NEUTRAL STEER position (TM 5-2410-241-10).
43. Release service brake (TM 5-2410-241-10).
44. Set machine to LOW IDLE (TURTLE MODE) on the throttle switch (TM 5-2410-241-10).
45. Apply parking brake (TM 5-2410-241-10).
46. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
Figure 7. Pressure Gauge.
0033
