TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Engine Flood Lamp Does
32. Turn engine compartment lamp
Not Work - Continued
switch to ON position (TM 5-2410-
241-10).
33. Using digital multimeter (WP
1. If continuity is NOT found, pro-
0296), test for continuity between
ceed to step 34.
pin 30 ion fuse panel wiring har-
2. If continuity is found, replace fuse
ness connector A-C1 (WP 0018,
panel wiring harness (WP 0176).
Figure 22) to machine ground.
Replace Fuse #16 (TM 5-2410-
241-10). Ensure all harness con-
nectors are reconnected. Verify
correct operation of machine (TM
5-2410-241-10).
34. Disconnect engine harness con-
nector V-C1 (WP 0018 Figure 12)
from platform harness connector
MA-C22 (WP 0018, Figure 11).
35. Using digital multimeter (WP
1. If continuity is found, replace main
0296), test for continuity between
engine harness (WP 0055).
pin 3 and pin 8 on engine harness
Replace Fuse #16 (TM 5-2410-
connector V-C1 (WP 0018,
241-10). Ensure all harness con-
Figure 12).
nectors are reconnected. Verify
correct operation of machine (TM
5-2410-241-10).
2. If continuity is NOT found, replace
platform harness (WP 0209).
Replace Fuse #16 (TM 5-2410-
241-10). Ensure all harness con-
nectors are reconnected. Verify
correct operation of machine (TM
5-2410-241-10).
All Windshield Wipers and
1. Inspect operation of all windshield
1. If all windshield wipers and wash-
Washers Do NOT Oper-
wipers and washers (TM 5-2410-
ers do NOT operate, proceed to
ate.
241-10).
step 2.
2. If one windshield wiper or washer
does NOT operate, proceed to
Troubleshooting Index for correct
symptom (WP 0013).
N OT E
Ensure all wiper switches are turned to the OFF position.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).