TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ROPS Mounted Rearward
100.Disconnect right rear flood lamp
Facing Floodlamp(s) Do
harness connector TJ-C3 (WP
Not Work - Continued
0018, Figure 104) from fuel tank
harness connector TW-C5 (WP
0018, Figure 106).
101.Using digital multimeter (WP
1. If continuity is found, replace right
0296), test for continuity between
rear flood lamp harness (WP
pin 1 and pin 2 on right rear flood
0154). Replace Fuse #9 (TM 5-
lamp harness connector TJ-C3
2410-241-10). Ensure all harness
(WP 0018, Figure 104).
connectors are reconnected. Ver-
ify correct operation of machine
(TM 5-2410-241-10).
2. If continuity is NOT found, replace
fuel tank harness (WP 0170).
Replace Fuse #9 (TM 5-2410-
241-10). Ensure all harness con-
nectors are reconnected. Verify
correct operation of machine (TM
5-2410-241-10).
Engine Flood Lamp Does
1. Inspect operation of engine flood
1. If flood lamp does NOT work, pro-
Not Work
lamp (TM 5-2410-241-10).
ceed to step 2.
2. If problem is found, resume nor-
mal operation (TM 5-2410-241-
10).
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
3. Disconnect engine harness con-
nector V-C16 (WP 0018, Figure
110) from engine flood lamp.
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-241-10).
5. Turn engine compartment lamp
switch to ON position (TM 5-2410-
241-10).
6. Using digital multimeter (WP
1. If 24 Volts is found, proceed to
0296), measure for voltage
step 7.
between pin 1 and 2 on engine
2. If 24 Volts is NOT found, proceed
harness connector V-C16 (WP
to step 12.
0018, Figure 110).
7. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
8. Remove and disassemble engine
Flood Lamp (WP 0253).