TM 5-2410-241-23-2
0108
REMOVAL CONTINUED
Figure 2. Cylinder Head.
0108
CLEANING AND INSPECTION
000108
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0295).
END OF TASK
INSTALLATION
000108
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may cause injury or death to personnel.
N OT E
Cylinder head weighs approximately 300 lb (135 kg).
1. Attach lifting device to cylinder head (Figure 2, Item 1).
2. Using lifting device install six new O-rings (Figure 2, Item 3), new cylinder head gasket (Figure 2, Item 2) and
cylinder head (Figure 2, Item 1) on engine (Figure 2, Item 4).
3. Remove lifting device from cylinder head (Figure 2, Item 1).
