TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ROPS Mounted Rearward
48. Using digital multimeter (WP
1. If 24 Volts is found, proceed to
Facing Floodlamp(s) Do
0296), measure for voltage
step 49.
Not Work - Continued
between pin 1 and 2 on right rear
2. If 24 Volts is NOT found, proceed
flood lamp harness connector
to step 61.
TJ-C1 (WP 0018, Figure 108).
49. Using digital multimeter (WP
1. If 24 Volts is found, proceed to
0296), measure for voltage
step 50.
between pin 1 and 2 on left rear
2. If 24 Volts is NOT found, proceed
flood lamp harness connector
to step 61.
TK-C1 (WP 0018, Figure 107).
50. Turn rear facing floodlight switch to
OFF position (TM 5-2410-241-
10).
51. Turn main light switch to OFF
position (TM 5-2410-241-10).
52. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
53. Remove and disassemble right
rearward facing flood lamp (WP
0210).
54. Inspect inside of right rearward
1. If corrosion or damage is found,
facing flood lamp for corrosion
replace right rearward facing flood
and damage.
lamp assembly (WP 0252).
Proceed to step 57.
2. If corrosion and damage is NOT
found, proceed to step 55.
55. Using digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 56.
pin 1 and terminal 4 on right rear-
2. If continuity is NOT found, replace
ward facing flood lamp (WP 0018,
right rearward facing flood lamp
Figure 180).
assembly (WP 0252).
Proceed to step 57.
56. Using digital multimeter (WP
1. If continuity is found, replace right
0296), test for continuity between
rearward facing flood lamp bulb
pin 2 and terminal 3 on right rear-
(WP 0252).
ward facing flood lamp (WP 0018,
Proceed to step 57.
Figure 180).
2. If continuity is NOT found, replace
right rearward facing flood lamp
assembly (WP 0252).
Proceed to step 57.
57. Remove and disassemble left
rearward facing flood lamp (WP
0210).
0022-32